CS875-575-375-275-175 Installers Manual with CS5500 keypadB.11.3
5. If you a recording a single message, press the recording/playback button to stop recording. The message is
played back.
6. If you are satisfied with the message, press the recording/playback button to record the next message. Do not
start recording the next message while the recording/playback LED is lit.
7. To re-record a message, press the recording/playback button twice in quick succession and re-record the
message.
8. If you are recording a range of messages, continue recording each message until you have finished. All the
messages are played back in sequence when you have recorded and played back the final message.
9. Record all messages finishing with the address message.
11.3.3 Playing back messages
Pre-recorded voice messages can be played back altogether or one at a time. The following steps explain how to
playback different messages.
1. Connect a telephone handset to the phone jack on the CS535 voice module.
2. Navigate with the µ¶ keys to CS535 Voice Module>Playback and press OK.
- To playback all messages, scroll to All in Sequence and press OK.
- To playback one message at a time, scroll to the relevant menu option and press OK.
- To playback a single event message, scroll to Single Event Message and press OK. Select the number of
the message (1-15) and press OK.
- To playback a range of event messages, scroll to Multiple Event Message and press OK. Select the
number of the first message (1-15) and press OK.
3. Press the recording/playback button on the CS535 voice module to playback the message.
4. Press the recording/playback button to playback the next message.
11.3.4 Configuring handshake and kiss off
Handshake and kiss off can be programmed as any key press or as a specific telephone key. The following steps
explain how to configure these digits.
< The voice protocol cannot generate a ‘fail to communicate’ signal.
1. Navigate with the µ¶ keys to CS535 Voice Module>Handshake Digit and press OK.
2. Select the handshake digit and press OK.
3. The keypad beeps once to accept the change.
4. Scroll to Kiss Off Digit and press OK.
• Select the kiss off digit and press OK.
• Select Any Digit to program any key press as the handshake/kiss off digit. This is the default.
• Select None to disable kiss off.
5. The keypad beeps once to accept the change.
To Next Page
Loading...
Need help?
General
