CS875-575-375-275-175 Installers Manual with CS5500 keypad B.1.1
Chapter 1: Enrolling modules
To enroll and default the system modules, you must enable the advanced menu. Select Commands>Advanced
Menu>Enabled and press OK.
1.1 Enrolling the system modules
When you select the enrol modules process, new modules are enrolled on both the control panel and the keypad.
The keypad must enrol modules in order to display the relevant menu options.
1. Press OK at the system prompt and enter your installer code.
2. Navigate with the µ¶ keys to Enrol Modules>Enrol and press OK.
3. The keypad starts enrolling the modules. The Enrolling message is displayed while enrolment is taking
place (approximately 12 seconds). When the modules have been enrolled, a beep sounds and the message
disappears.
4. When the modules have been enrolled, the keypad returns to Enrol.
5. Verify the enrolled modules. Navigate with the µ¶ keys to Commands and press OK.
6. Scroll to Event Log and press OK. When the control panel enrols a module, it adds an enrol event to the
event log. This event contains the module number. Scroll through the event log to verify that each module
has been enrolled.
<
The modules are enrolled each time you leave programming mode. In this case, the Enrolling message is
displayed but no beep sounds.
1.2 Defaulting the modules
Each module can be defaulted. It is recommended that you default each module before modifying its settings.
1. Navigate with the µ¶ keys to Default Settings in the relevant module menu and press OK. In this case,
select Control Panel>Default Settings to restore the default control panel settings.
2. A confirmation message is displayed. Press OK to accept the default settings.
3. The keypad sounder beeps once to confirm the reset.
1.3 Glossary
Location Term Definition
1 Enrol Modules A menu option that activates the process by which the control makes an internal list of all
keypads and modules connected to the system.
1.1 Enrol A menu entry that groups enrolled module information.
1.2 Number of Modules A menu option that displays the total number of installed modules.
Enrol
Number of Modules
1.1
1.2
To Next Page
Loading...
Need help?
General
