CS875-575-375-275-175 Installers Manual with CS5500 keypad B.17.2
17.2 Event log events
Table 17-2: Event list
Event message Explanation
Alarm An alarm has been tripped.
Alarm Restore See Alarm event message.
Autotest An autotest message was sent to the central station.
B-Alarm A full alarm on a B zone type that is considered a burglary alarm.
Box Tamper A box tamper.
Box Tamper Restore See Box Tamper event message.
Burglary A burglary zone has been tripped.
Burglary Restore See Burglary event message.
Bypass A zone is bypassed.
Bypass Restore See Bypass event message.
Cancel The report to the central station has been cancelled. This occurs when a user enters a code after an alarm.
CleanMe A smoke detector is dirty.
CleanMe Restore See CleanMe event message.
Clock Set A user set the date and time.
Close (arm) Closing (arm) by a specific user.
Code Entry The lock of the access reader has been triggered.
The lock can be triggered by an accepted proximity card or by an Egress switch. An Egress switch is a button that can
be pressed by a user to open the lock of the door. It can also be called Request-to-Exit (RTE). When the Code Entry
option is activated, the reader sends a log message to the control panel, indicating that the lock has been triggered.
Data Lost The panel has been unable to send alarm messages to the central station. The panel tries to send these messages a
number of times as specified in the FTC (Dial attempts before Fail to Communicate). Any pending reportable events are
lost.
Disarm from Alarm A user disarmed the panel during an alarm.
Duress A duress code entered by a user. An alarm message is sent to the central station.
Early Open A user disarmed the system before the open time specified in the panel schedules.
End Download The end of an up/download.
End Prog End programming. The installer left programming mode.
End Walktest See Walktest event message.
Enrolled Modules are enrolled on the bus. The module numbers are recorded.
Exit Error An exit door remained open after the exit delay expired.
Expander Trouble A problem with an expander module.
Expander Trouble
Restore
See Expander Trouble event message.
Expansion Event A bus device generated an event to report conditions not described by other events.
Fail to Communicate The control panel or module tried to send a message to a central station but failed.
Fire A fire alarm has been tripped.
To Next Page
Loading...
Need help?
General
