GE Security CS275 User Manual

CS875-575-375-275-175 Installers Manual with CS5500 keypad B.17.4
17.3 Glossary
Siren Tamper Restore See Siren Tamper event message.
Start Download The start of an up/download.
Start Prog Start programming. The installer entered programming mode.
Tamper A tamper.
Tamper Restore See Tamper event message.
Telephone Fault Telephone line faults.
Telephone Fault Restore See Telephone Fault event message.
Trouble A trouble condition.
Trouble Restore See Trouble event message.
Walktest The start/end of a walktest.
Zone Inactive Restore See Zone Inactivity event message.
Zone Inactivity A zone inactivity monitoring event.
Zone Lost An RF transmitter has lost the supervision with the wireless receiver. This happens when the transmitter has not
reported its supervision message to the RF receiver within the long supervision window. See appendix 5.
Zone Lost Restore See Zone Lost event message.
10 unsuccessful
download attempts
This is a security feature. This event occurs if someone tries to hack into the system.
Location Term Definition
17 Commands A menu entry that groups options relating to issuing commands by the
installer.
17.1 Alarm Memory A menu option that displays a list of alarms and where they occurred. Only the
alarms that have occurred during the last arm/disarm cycle are shown in the
alarm memory log.
17.2 Reset Smoke Detector A menu command that resets two-wire and four-wire smoke detectors and the
Fire LED. For hardwired smoke detectors, the power supply to the smoke
detectors is cut temporarily.
RF smoke detectors have an auto reset because the RF communication is uni-
directional (from RF detector to RF receiver). This command does not reset RF
smoke detectors but should still be used to reset the Fire LED.
17.3 Service Check A menu command that is used to verify service messages.
The service message disappears when the installer enters and then leaves
programming mode. If Master Code Resets Tamper Memory is enabled, a
master user can reset the service message by entering a master user code.
17.4 Do Self Test A menu command that performs the keypad LED and LCD test and the
manual tests enabled in Diagnostics. The siren is activated during the tests if
the Manual Siren menu option is enabled. Likewise, a manual test call is made
to the central station if the Manual Dialler Test menu option is enabled.
Table 17-2: Event list
Event message Explanation

GE Security CS275 Specifications

General

Brand	GE Security
Model	CS275
Category	Security System
Language	English