38 TruVision DVR 40 User Manual
Setting the device ID
When you use the IR remote control to operate the TVR 40, the TVR 40 must have a device ID. The
default device ID is “01“. If there is more than one DVR used, each unit must have its own unique
device ID as otherwise the IR remote control will control all the units together.
To set the TVR 40’s device ID
Front panel or remote
control
In the Display menu go to the Bus Address edit box and press F1. Using the
number buttons, enter the number of the device ID.
Mouse In the Display menu go to the Bus Address edit box and left-click the mouse.
Select the number from the on-screen numeric display.
When you have made all the changes required in the Display menu, go to OK and press Enter or
left-click the mouse to save all changes and return to the main menu. Press the Menu button to
return to live mode.
Setting the PIN requirement
A PIN is required by default to access the TVR 40. See “Modifying a user’s PIN” on page 89 for
information on PINs.
To setup the PIN requirement
1. In the Display menu go to the Log In PIN Required check box and press Enter or left-click the
mouse to enable () or disable it
2. When you have made all the changes required in the Display menu, go to OK and press Enter or
left-click the mouse to save all changes and return to the main menu. Press the Menu button to
return to live mode.
Displaying the status bar
The status bar appears on-screen by default.
To display the status bar
1. In the Display menu go to the Status Bar check box and press the joystick or left-click the mouse
to enable () or disable it.
2. When you have made all the changes required in the Display menu, go to OK and press Enter or
left-click the mouse to save all changes and return to the main menu. Press the Menu button to
return to live mode.
To Next Page
Loading...
