GE Hydran M2-X - Page 160

Hydran* M2-X Instruction Manual
Page 160
MA-029 Rev. 1.0, 30-Jul-18
Parameter Name
Sensor Temp.
Alarm
Heater Plate Temp.
Alarm
Alarm Low SP
˚C
˚C
Alarm Hi SP
˚C
˚C
Alarm Hi-Hi SP
˚C
˚C
Alarm Delay
min
min
Alr C. Open Relay
1[ ] 2[ ] 3[ ] 4[ ]
1[ ] 2[ ] 3[ ] 4[ ]
Alarm Low Relay
1[ ] 2[ ] 3[ ] 4[ ]
1[ ] 2[ ] 3[ ] 4[ ]
Alarm Hi Relay
1[ ] 2[ ] 3[ ] 4[ ]
1[ ] 2[ ] 3[ ] 4[ ]
Alr C. Short Relay
1[ ] 2[ ] 3[ ] 4[ ]
1[ ] 2[ ] 3[ ] 4[ ]
Table B - 3: Logging the Values of the Temp. Alarm Setup Parameters
11. Set the Battery Alarm Setup parameters
[ ]
• Alarm Low-Low SP to _________ V
[ ]
• Set Alarm Low SP to _________ V
[ ]
• Set Alarm Delay to _________ minutes
[ ]
12. If input modules are installed, set the Analog Input Alarm Setup parameters
(log values in Table B-4)
[ ]
13. Set the Sys. Fault Trigger parameters
[ ]
4.4.4
Verifying the Battery Voltage
93
4.4.5
Setting the Dynamic Oil Sampling System Parameters
93
1. Set Temp Set Point to _________ °C
[ ]
2. Set Temp SP Modulation to _________ °C
[ ]
3. Set Temp Mod. Period to _________ minutes
[ ]
4.4.6
Setting the Readings Parameters
94
1. Set the Gas Reading Setup parameters:
• Set Hourly Tr. Period to _________ hours
[ ]
• Set Daily Tr. Period to _________ days
[ ]
• Set Hydran PPM Period B to _________ hours
[ ]
2. Set the H2O Reading Setup parameters:
• Set %RH Average to _________ hours
[ ]
• Set PPM H2O Avg. to _________ hours
[ ]