EasyManua.ls Logo

GE Hydran M2-X - Page 189

GE Hydran M2-X
204 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 189
Hydran* M2-X Instruction Manual
MA-029 Rev. 1.0, 30-Jul-18
SensorCaution OFF Sensor Caution alarm turned off
SensorCaution ON Sensor Caution alarm turned on
RTC Bad Real-time clock has failed
SensTstAlr Ack Sensor fail alarm has been acknowledged
SetupLost Ack Setup lost alarm has been acknowledged
SetupLost OFF Setup lost alarm turned off
Set-up Lost ON Setup lost alarm turned on
Soft WatchDog Reset of Hydran M2-X induced by the software watchdog
Sp Span chg Modification of the sensor temperature set point’s range
STempAlr Ack Sensor temperature fail alarm has been acknowledged
STempAlr H chg Modification of the sensor temperature High alarm’s set
point
STempAlr H ON Sensor temperature High alarm turned on
STempAlr HH chg Modification of the sensor temperature High-High alarm’s set
point
STempAlr HH ON Sensor temperature High-High alarm turned on
STempAlr L chg Modification of the sensor temperature Low alarm’s set point
STempAlr L ON Sensor temperature Low alarm turned on
STempAlr LL chg Modification of the sensor temperature Low-Low alarm’s set
point
STempAlr LL ON Sensor temperature Low-Low alarm turned on
STempDelay chg Modification of the sensor temperature alarm’s delay
STemp H OFF Sensor temperature High alarm turned off
STemp HH OFF Sensor temperature High-High alarm turned off
STemp L OFF Sensor temperature Low alarm turned off
STemp LL OFF Sensor temperature Low-Low alarm turned off
STempSetP chg Modification of the sensor temperature set point
SystemCalib Calibration of Hydran M2-X
TDM Mode chg Modification of the TDM signal’s operating mode
Unit in Service Hydran M2-X back in service after the battery was
disconnected
Watchdog Reset of Hydran M2-X induced by the hardware watchdog

Table of Contents

Other manuals for GE Hydran M2-X

Related product manuals