GE LOGIQ 400 - Page 412

GE MEDICAL SYSTEMS
2127661
LOGIQ 400 SERVICE MANUAL

RENEWAL PARTS
6–282
REV 9
6–7–4 Procedures (continued)
(B) Installing LV3 Unit (continued)
4. Unscrew four (4) screws (
1
–
4
). Refer to ILLUSTRATION 6–167.
5. Remove the Right PS Cover. Refer to ILLUSTRATION 6–167.
6. Unscrew three (3) screws (
5
–
7
). Refer to ILLUSTRATION 6–167.
7. Disconnect one connector (
8
). Refer to ILLUSTRATION 6–167.
8. Pull the HV Unit out.
RIGHT SIDE VIEW OF POWER SUPPLY
ILLUSTRATION 6–167
Note
It is not necessary to remove the HV Unit completely. Pull the HV Unit out to get the openings for
accessing the rear of the LV3 Unit by a hand.