GE MEDICAL SYSTEMS
2127661
LOGIQ 400 SERVICE MANUAL
TM
8–37 OPTIONS
REV 5
8–3–10 Operational Check–out (Continued)
Note
When installing the UP–3030 printer, the “UP3030” shall be selected for the Color Printer Type pa-
rameter on the SYSTEM PARAMETER SETUP menu.
Note
When installing the UP–2950MD or UP–2850P printer, the “UP1850” shall be selected for the Color
Printer Type parameter on the SYSTEM PARAMETER SETUP menu.
a. Press the Top Menu Select key located on the keyboard. The sub–menu selected previously is displayed on
the CRT monitor screen.
SOFTWARE MENU CONTROL KEYS
ILLUSTRATION 8–40
b. Press the Top Menu Select key again. The top menu is displayed on CRT monitor screen as shown in
ILLUSTRATION 8–41.
TOP MENU
ILLUSTRATION 8–41
c. Select the Set Up Menu using the or key of Sub Menu Select keys. The Set Up selection is dis-
played in reverse video as shown in ILLUSTRATION 8–41.
To Next Page
Loading...
