DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
3 - 32 Section 3-4 - Completing the setup
To change your password:
You can change your password when first logging onto the system.
1.) Type your name in the Operator field.
2.) Press the Change Password button. The Change Password pop-up displays.
3.) Type the following:
- Password: Type your current password.
- New Password: Type your new password.
- Confirm Password: Retype your new password.
4.) Press OK to confirm your changes, or Cancel to cancel your changes.
Figure 3-20 Change Password Pop Up
To Next Page
Loading...
