DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 4 Functional Checks 4 - 23
Cineloop Checks
For complete information, refer to the appropriate version of the LOGIQ E10 Basic User Manual,
Chapter 5, or the appropriate LOGIQ E10 Release Notes. See: Section 1-5 "Label locations" on page
1-26.
To Activate CINE
1.) Press Freeze, then roll the Trackball to activate CINE.
2.) To start CINE Loop playback, press Run/Stop. To stop CINE Loop playback, press Run/Stop.
To Omit Images
- Roll the Trackball to the frame you want to delete and press Omit Image.
To Restore Images
- To undo deleting an image from the CINE Loop, press Restore Image.
To Move Quickly to Start/End Frame
1.) Press First to move to the first CINE frame.
2.) Press Last to move to the last CINE frame.
To Start Frame/End Frame
1.) Turn the Start Frame dial to the left to move to the beginning of the CINE Loop. Turn the dial
to the right to move forward through the CINE Loop.
2.) Turn the End Frame dial to the right to move to the end of the CINE Loop. Turn the dial to the
left to move backward through the CINE Loop.
To Adjust the CINE Loop Playback Speed
- Turn the Loop Speed dial right/left to increase/decrease the CINE Loop playback speed.
To Move through a CINE Loop Frame By Frame
- Turn Frame by Frame to move through CINE memory one frame at a time.
Checks
- Check Left Marker, Right Marker, Cycle Select and Number of Cycles
- Check First, Last Cycle, Select all
- Adjust Scroll and Cine Speed
To Next Page
Loading...
Need help?
General
