DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
5 - 4 Section 5-3 - LOGIQ E10 description
5-3-3 LOGIQ E10 general description
LOGIQ E10 is a digital beamforming Ultrasound system. Signal flow travels from the Probe Connector
Panel to the Front End Electronics, then to the ECB (LOGIQ E10 Carrier Board), and finally, the results
are displayed on the monitor
System configuration is stored on the hard drive and all necessary software is loaded from the hard drive
on power up.
The LOGIQ E10 is comprised of the following major components:
•Front End
• Back End
• OP Panel
• Peripherals
• Options
• Power Distribution
• Mechanical Parts
• Software
To Next Page
Loading...
