DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 6 Service Adjustments 6 - 3
6-2-2 Access to Adjustments
Brightness and Contrast adjustments can be done through touch panel encoders under the Utilities
screen.
All Monitor settings have been optimized at the factory, so normally, there should be no need for any
further adjustments.
Under special lighting conditions, you may want to adjust the Monitor screen’s backlight intensity.
Factory default settings are:
• Brightness 50%
• Contrast 40%
• Room Setting: Dark
For complete information, refer to the appropriate version of the LOGIQ E10 Basic User Manual
Chapter 3, or the appropriate LOGIQ E10 Release Notes. See: Section 1-5 "Label locations" on page
1-26.
To Next Page
Loading...
