DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 8 Replacement Procedures 8 - 115
A/N Keyboard Mechanics replacement
Table 8-133 A/N Keyboard Mechanics replacement
Steps Corresponding Graphic
1. Disconnect the Keyboard
Mechanics signal Cable.
Grasp the connector on the large,
flat sides and pull straight away
from the board.
2. Re-install the Cover onto the Keyboard Mechanics.
Make sure the Cover is completely around the Keyboard Mechanics, so the Mechanics and
Cover are installed correctly.
Re-connect the signal Cable.
Place any excess Cable into the Lower Frame when re-installing the Keyboard.
3. Re-install all Covers removed.
To Next Page
Loading...
