DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 8 Replacement Procedures 8 - 293
BIOS Battery replacement
Table 8-319 BIOS Battery replacement
Steps Corresponding Graphic
1.
The BIOS Battery is located on the ECB.
Remove the Battery and replace it.
2. Carefully install the ECB.
3. Install the Card Rack Cover and fasten it with the fixing screws.
Connect the Hi-Pass cable to the GRLY Board and re-install the cover, if present.
4. Re-install all Covers removed.
To Next Page
Loading...
