GE Reason H49 - Page 138

Technical Manual
GE Reason H49
138
H49/EN M/C22
Front Panel
The frontpanel command allows interacting with the front panel:
frontpanel –a <ip address> -l <state>
command parameter Description Values
frontpanel
-a
Sets the device IP address on the front panel xxx.xxx.xxx.xxx
-c
Updates LEDs on the front panel
-l
Enables/disables led chaser enable, disable
-y
Copies the command information in a YAML format
AlarmContact
The alarmContact command allows you to configure the behaviour of the alarm
relay:
alarmContact [-c <contact>] [-f <state>] -S -i
command parameter Description Values
alarmContact
-c
Contact number 1,2
-f
Force Logic Output State unforced, energized, unenergized
Global Status
The system command allows you to configure the global settings of the system.
system [-a <IP Address>] [-n <netmask>] [-g <gateway>] [-s
<DNS IP Address>] [-m <MAC Address>] [-t<name>] -S -i
command parameter Description Values Default
system
-a
Sets the Reason H49 IP Address 192.168.254.254
-n
Sets the Reason H49 net mask 0 to 32 16
-m
Sets MAC Address. Restart is needed
-c
Sets the Reason H49 name
-g
Sets Gateway IP address 0.0.0.0
-s
Sets DNS Server IP Address 10.18.0.134
-t
Sets synchronization time local, ntp, ptp ptp
The following values can be set the Time zone of the Reason H49:
command parameter Description Values
timezone
-z
Sets the time zone