GE Reason H49 - Alarm Contact

Technical Manual
GE Reason H49
150
H49/EN M/C22
12.2.1.3 Switch
The example below shows the use of the switch command line:
Command Description
switch -m
Sets the switching mode
Example:
switch –m adaptative
12.2.1.4 Alarm Contact
The example below shows the use of the alarmContact command line:
Command Description
alarmContact -c -f -c -f
Sets the Logic Output State of each contact
Example:
alarmContact –c 1 –f unforced –c 2 –f unforced