VLAN Tag
Enable or disable the VLAN tag for PTP messages.
Attribute Description Factory Default
VLAN ID
Set the VLAN ID of the PTP frames.
0
PCP ID
Set the priority code point (PCP) of the PTP frames.
4
7.4.1.3 Redundancy Mode
Setting up communication redundancy on your network provides a backup data
transmission route in the event that the communication is lost.
To set up the H49 redundancy mode, click System > Redundancy Mode.
Click the desired redundancy mode among the preset switch configurations:
Selected Redundancy Mode Description
None
Uses Reason H49 as a standard switch.
All the ports are enabled by default.
PRP RedBox
Ports 1 and 2 are reserved for redundant connection to
LAN A and LAN B respectively.
4 Ports are available for SAN connections.
HSR-PRP Coupling RedBox
• Ports 1 and 2 are reserved for redundant
connection to HSR ring.
• Port 3 is reserved for one of the PRP LANs.
• 3 Ports are available for SAN connections.
HSR RedBox
Ports 1 and 2 are reserved for redundant connection to
HSR ring.
4 Ports are available for SAN connections.
HSR QuadBox
In this configuration, 4 ports are reserved for coupling
functions.
• Ports 1 & 2 are reserved for redundant connection
to HSR ring A.
• Ports 3 & 4 are reserved for redundant connection
to HSR ring B.
The two remaining ports are inoperative.
Note:
Pay attention when using this configuration since no
more standard Ethernet ports will be available and you
will need to connect to the device by using an HSR
compliant device (another H49 for example).
To Next Page
Loading...
