GE Reason H49 - Figure 79: Reason H49 Web User Interface - Security Configuration; Security Settings

GE Reason H49
Technical Manual
H49/EN M/C22
93
7.4.3 Security
This section is divided into four pages:
• Security settings
• User Accounts
• LDAP Server
• Syslog server
7.4.3.1 Security Settings
To configure security settings, click Security > Security Settings.
From this page, you can set the user and system management parameters and
manage TLS and trusted certificates.
Figure 79: Reason H49 Web User Interface – Security Configuration
Sy
stem
Set the system security settings as described below:
Attribute Description
Inactivity Period
Sets the inactivity period before disconnecting a user.
If Period equals 0, then no disconnection time will be applied.