GE Reason H49 - Figure 25: Typical 2-Way Female Connector

GE Reason H49
Technical Manual
H49/EN M/C22
45
BIU261D primary power supply
Pin n° Description
1 to 21 Not used
22 Voltage input: GND
23 Voltage input: AC/DC ( + )
24 Voltage input: AC/DC ( - )
Note:
Inputs must be connected to the specified pins. Other pins must remain unused and no other connection has to be made.
The 24-way connector block characteristics are as follows:
• Continuous rating 10A
• Connection method M3 screws
• Cable section 2.5mm2
• Connection pitch 5.08mm
• Insulation between terminals and to the earth 300 V basic insulation
• Standards UL, CSA
Note:
The connector is fixed using 2 M3 screws located at each end of the connector.
BIU261D secondary power supply
The secondary power supply is connected using a 2-way connector block:
Figure 25: Typical 2-way Female Connector
Pin n° Description
1 Voltage input: DC ( + )
2 Voltage input: DC ( - )