GE Reason H49 - Figure 45: Reason H49 Web User Interface - PRP Redbox Mode Selected

GE Reason H49
Technical Manual
H49/EN M/C22
69
Redundancy Mode Details
The lower part of the page changes according to the selected redundancy mode
(highlighted in blue):
Figure 45: Reason H49 Web User Interface – PRP RedBox Mode Selected
Set the settings for the selected redundancy mode:
Attribute Description
Supervision Mac Address Set the PRP or HSR supervision Mac Address
Network ID
Only displayed for “HSR/PRP coupling” redundancy mode.
It is an integer between 1 and 6 allowing the device to
identify the network and to avoid duplicated packages.
Note: When coupling rings with two RedBoxes, both
RedBoxes must be configured with the same Network ID.
LAN ID
Only displayed for “HSR/PRP coupling” redundancy mode.
It identifies the PRP LAN to be connected to the device.
Note: When coupling a ring with two RedBoxes, one shall
be set on LAN A and the other one shall be set on LAN B.
Pay attention not to configure both RedBoxes on the
same LAN.
Note:
When switching from one redundancy mode to another, reboot Reason H49 to apply changes in the Start-up configuration. The
system and network configuration will be erased except the Name; IP address; Subnet mask and Gateway attributes set in the
Global Settings > System page. The security settings will be kept.