GE Reason H49 - Figure 29: SFP Module Connection; Ethernet Connections

GE Reason H49
Technical Manual
H49/EN M/C22
49
6.5 Ethernet Connections
Reason H49 is easy to install and operate. It is designed to work in an electrical plant
environment and it is fully certified IEEE 1613 series, IEC 61850-3 and IEC 60255-27.
Reason H49 connects to the network through a Small Form-factor Pluggable module
(SFP), which can be inserted and removed safely while the switch is powered and
operating:
S1353ENa
Figure 29: SFP Module Connection
The SFP module is a hot-swappable connector that provides high-speed performance.
Reason H49 supports two kinds of modules:
• Optical LC-type SFP
• RJ45-type SFP.
The table below lists the supported LC-type SFP and references:
Reference Manufacturer Description Connector Type Image
AFBR-5715ALZ fit-foxconn
1Gbps Multimode
850nm wavelength
LC Duplex
HFBR-57E0APZ AVAGO
100Mbps Multimode
1300 nm wavelength
LC Duplex
AFCT-5765ALZ fit-foxconn
100Mbps Single-mode SR
(up to 2 km)
1300 nm wavelength
LC Duplex