7.4.2 Network
This section provides the current network configuration of the Reason H49 switch.
7.4.2.1 Interface
This page allows the user to configure the device’s interfaces available in the selected
redundancy mode.
Each interface is represented by a row in the table.
Figure 66: Reason H49 Web User Interface – Interface Configuration
Note:
When the device is configured in QuadBox mode, ports 5 and 6 are deactivated, thus they are not displayed in the list.
Caution:
Be careful not to disable the port you are using for configuring the device. In the
same manner, do not disable all the ports since it will not be possible to connect
to the device afterwards. If, for any reason, you have disabled all the ports,
reboot manually the device to reload the “Startup” configuration that is supposed
to be correct.
To Next Page
Loading...
