GE Reason H49 - Page 82

Technical Manual
GE Reason H49
82
H49/EN M/C22
Set the interface attributes as detailed in the table below:
Attribute Description
Enable Check the box to enable a port.
Interface Mode
Reason H49 interfaces can be configured either as access ports or a trunk ports, as follows:
• Access: An access port can have only one VLAN configured on the interface; it can carry
traffic for only one VLAN,
Reason H49
Port 5
(Access port VLAN ID 2)
Port 6
(
Access port VLAN ID 4
)
Device D
VLAN
4
Device E
VLAN 2
•
Trunk: A trunk port can have two or more VLANs configured on the interface; it can carry
traffic for several VLANs simultaneously. Usually trunk link connection is used
to connect two
switches or switch to router.
Reason H49 Reason H49
Port 4
(Trunk port VLAN ID 1)
Caution:
Wrong VLAN setting on access ports may cause communication failure with Reason H49.
In such a case, you shall reset the switch to factory-default configuration, as explained in
section “Revert to Default Factory Configuration”.
Link Mode
Select the link mode to be used for copper SFP (10Mbps Full Duplex, 100Mbps Full Duplex, 1000Mbps Full
Duplex, Auto-negotiation)
This attribute is disabled if the interface is optic fiber.
VLAN Tag Check the box to enable the 802.1Q tag for VLAN and Priority Code Point (PCP) tags
Default VLAN ID
Enter the default VLAN ID (VID) for untagged devices that connect to that port
Default PCP Enter the default Priority Code Point of the interface (0 to 7)