GE Reason H49 - Figure 37: H49 Web User Interface - Power Supply Status; System

GE Reason H49
Technical Manual
H49/EN M/C22
59
7.4.1 System
The System section provides the current configuration of the Reason H49 switch
together with its status.
It also allows the user to update the main system attributes.
7.4.1.1 Status
To get the global status of the Reason H49 switch, click Status in the System
section:
The top part of the page shows the following information:
Attribute Description
Redundancy mode Selected redundancy mode
IP address Device’s IP address
MAC address Device’s MAC address
Date & Time Device’s clock date and time
Uptime Elapsed time since last reboot
Firmware Version Version of the firmware currently running on the device
L
ED Chaser
The LED chaser of the H49 is a function used to identify correctly a given device
amongst others.
It consists in sequentially lighting all the LEDs in the front panel one after the other,
eight at a time.
• Click Enable LED Chaser to activate the LED chaser and make the device’s LEDs
b
link in sequence.
• Click again to stop the LED chaser (Disable LED Chaser button), or press the “C”
button on the device front panel.
Alternatively, the LED chaser can be stopped by pressing the “C” button in the front
panel.
Supply Status
This area shows information about the input voltage sources (Primary voltage
source/Secondary voltage source):
Figure 37: H49 Web User Interface – Power Supply Status