5.3 Mounting
Reason H49 is designed to be mounted vertically on a standard DIN Rail.
For this purpose, two adjustable mounting brackets are located on the back of the
H49, one at the top and one at the bottom of the rear face as shown below:
Figure 18: H49 DIN Rail Mounting Details - Rear View with Mounting Rack
Optional Weidmuller FM4 TS35 mounting clip can also be used, as shown in the
following figure (to be ordered separately).
Figure 19: H49 DIN Rail Mounting Details - Rear View with Weidmuller Clip
To Next Page
Loading...
