Configuration
Reason H49 runs internally two configuration files:
• Running Configuration: This file is the current configuration of the switch. When
the Apply button is pressed at any settings menu, changes made at the
configuration will be saved at this file. If the switch is restarted, this configuration
is discarded and the switch will load, after the reboot, the Startup Configuration
file;
• Startup Configuration: This file represents the configuration that the switch will
run after it is powered up or restarted. If a change in the Running Configuration
was performed and it is requested to maintain the Running Configuration at the
Startup Configuration, the user must save it using the Save Running as
Startup option, in the Management page;
Import a New Configuration File
To import a new configuration file to the device, perform the following steps:
• Click the “…” button to navigate to the folder that contains the configuration file
and then, select the relevant .yaml, yml file:
Figure 58: Reason H49 Web User Interface – Select the Configuration File to be imported
• Click “Change Running” to import the file.
Figure 59: Reason H49 Web User Interface – Start the Upgrade Process
At the end of the upgrade process, the new configuration is running on the device.
Only System and Network parameters are preserved in Running and Startup
configuration.
To Next Page
Loading...
