GE Reason H49 - CLI Commands

GE Reason H49
Technical Manual
H49/EN M/C22
137
12.1.4 CLI Commands
This section gathers the list of command lines that can be used to configure the
Reason H49 switch.
A command line is a combination of a command name, a parameter name and a
parameter value:
The general format is:
• command –parameter value
Example: to set the H49 sub mask, you can type: system -n 255.255.0.32
Note:
Command parameters are case-sensitive (for example –S has not the same effect as –s)
12.1.4.1 Common parameters
All commands support the following parameters:
Parameter Effect
-d
Displays the command description
-i
Displays information about the configuration
-h
Displays all parameters and values valid for the command
-v
Displays the command version
-S
Saves the settings (make the modifications permanent)
-D
Enables debugging mode.
-iy
Displays the configuration in YAML format
12.1.4.2 H49 System Commands
Switch
The switch command allows setting the switching mode of the device:
switch [-m <mode>] -S -i
command parameter Description Values
switch
-m
Sets the switching mode StoreAndForward, adaptative
-i
Displays configuration