The 2-way connector block characteristics are as follows:
• Continuous rating 10A
• Connection method M2.5 screws
• Cable section 2.5mm2
• Connection pitch 5.08mm
• Insulation between terminals and to the earth 300 V basic insulation
• Standards UL, CSA
If the primary power supply input is lost while being used, the BIU261D switches to
the secondary power supply input. It will switch back to the primary power supply
when the latter becomes available again and has been stable for a few seconds.
If the secondary power supply is lost while being used, the BIU261 instantly switches
to the primary power supply. It will continue to use the primary power supply source
as long as it is available, even when the secondary power supply becomes available
again.
Reason H49 supports the following power supply use cases:
Primary source Secondary source
Use case 1 DC DC
Use case 2 DC OFF
Use case 3 OFF DC
Use case 4 AC DC
Use case 5 AC OFF
Nominal Power supply range
85Vac to 230Vac
85Vdc 220Vdc
85Vdc 220Vdc
To Next Page
Loading...
