GE Reason H49 - Page 143

GE Reason H49
Technical Manual
H49/EN M/C22
143
Interface
The following values can be set to configure the Reason H49 interfaces.
interface <ifname> [-D] [-d] [-h] [-i] [-v] [-y]
command parameter Description Values
interface
ifname
Interface name CE01 to CE06
-s
Sets interface state Enable, disable
-m
Sets interface mode Trunk, access
-k
Sets link mode Autoneg, 1000full, 100full, 10full
-l
Sets default VLAN 1 to 4095
-n
Sets default PCP 0 to 7
-t
Sets VLAN tagging Enable, disable
-o
Sets default VLAN for VLAN0 0 to 4095
-0
Sets priority for PCP 0 0 to 3
-1
Sets priority for PCP 1 0 to 3
-2
Sets priority for PCP 2 0 to 3
-3
Sets priority for PCP 3 0 to 3
-4
Sets priority for PCP 4 0 to 3
-5
Sets priority for PCP 5 0 to 3
-6
Sets priority for PCP 6 0 to 3
-7
Sets priority for PCP 7 0 to 3
-c
Displays port counters (to be used with –i)
-f
Displays SFP Status (to be used with –i)