10.5.3 Auxiliary Fault Relays (Optical Port Alarm) 128
10.5.4 BIU261D 129
10.6 Ethernet Management 129
10.7 Manufacturer 130
CHAPTER 11: GLOSSARY 131
CHAPTER 12: APPENDICES 133
12.1 Appendix 1 Configuring Reason H49 from command lines 133
12.1.1 Prerequisites 133
12.1.2 Accessing the SSH configuration interface 133
12.1.3 Login to the H49 135
12.1.4 CLI Commands 137
12.2 Appendix 2 Command Line Use Cases 149
12.2.1 System Commands 149
12.2.2 Networks Commands 151
12.2.3 Security Commands 154
Table of Figures
Figure 1: Front View and Rear View 16
Figure 2: Reason H49 Bottom View 18
Figure 3: Example PRP Redundant Network 20
Figure 4: Reason H49 connecting up to four SANs to the PRP Network 21
Figure 5: Example HSR Redundant Network 22
Figure 6: Two QuadBoxes linking two HSR Rings 24
Figure 7: Coupling two PRP LANs to an SRS Ring 26
Figure 8: Coupling an HSR Ring to two PRP LANs 27
Figure 9: Coupling one HSR ring to several PRP Networks 28
Figure 10: Coupling Several HSR Rings to a PRP Network 29
Figure 11: Example of PRP/HSR Architecture with the Precision Time Protocol (PTP) 31
Figure 12: Example of NTP Synchronization 32
Figure 13: Front Face and side with dimensions 35
Figure 14: Example of Device Labeling 36
Figure 15: Manufacturing Label 37
Figure 16: Firmware Label 38
Figure 17: Manufacturer Label 38
Figure 18: H49 DIN Rail Mounting Details - Rear View with Mounting Rack 39
Figure 19: H49 DIN Rail Mounting Details - Rear View with Weidmuller Clip 39
Figure 20: Protective Earth Screw 42
Figure 21: Example of Earth Cable 43
Figure 22: Recommended mounting and Casing / Earth interconnection 43
Figure 23: Reason H49 Power Supply Wiring 44
Figure 24: Typical 24-way Female Connector 44
Figure 25: Typical 2-way Female Connector 45
Figure 26: Relay Alarm Wiring 47
Figure 27: Pluggable Terminal Block 47
Figure 28: Pluggable Terminal Block 48
Figure 29: SFP Module Connection 49
Figure 30: RJ45 SFP Module 51
Figure 31: Ethernet Fiber Optic – LC-type Module 52
To Next Page
Loading...
