GE Series 90-30 PLC - Option Modules; Third-Party Option Modules and the Accompany Program; Option Modules Discussed in this Chapter

GFK-0356Q 8-1
Option Modules
This chapter provides an overview of Series 90-30 Option modules. For detailed information, the
applicable user’s manual should be consulted (these manuals are listed for each module at the end
of its section).
Third-Party Option Modules and the Accompany Program
In addition to the modules discussed in this chapter, numerous third-party option modules (and
other hardware and software products) for the Series 90-30 PLC are available to meet a wide
variety of needs. Third-party companies that meet GE Fanuc’s standards may apply for recognition
under the GE Fanuc Accompany Program. Details on the Accompany Program are found in the
GE Fanuc Automation Solutions Catalog or on the GE Fanuc web site, both listed below. For
information on third-party modules, consult the following:
 Your GE Fanuc PLC distributor or sales engineer
 The GE Fanuc web site at
http://www.gefanuc.com
Option Modules Discussed in this Chapter
 IC693CMM301 Genius Communications Module (GCM)
 IC693CMM302 Enhanced Genius Communications Module (GCM+)
 IC693BEM331 Genius Bus Controller (GBC)
 IC693BEM340 FIP Bus Controller (FBC)
 IC693BEM330 FIP Remote I/O Scanner
 IC693APU301/302 Motion Mate Axis Positioning Module (APM)
 IC693DSM302 Motion Mate Digital Servo Module (DSM302)
 IC693DSM314 Motion Mate Digital Servo Module (DSM314)
 IC693APU300 High Speed Counter (HSC) Module
 IC693BEM320 I/O Link Interface Module
 IC693BEM321 I/O Link Master Module
 IC693APU305 I/O Processor Module
 IC693CMM321 Ethernet Interface Module
 IC693PCM300/301/311 Programmable Coprocessor Module (PCM)
8
Chapter