GFK-0356Q J-1
Ethernet Transceivers
IC649AEA102 Ethernet 10BASE-T Transceiver
• Compliant with the IEEE 802.3 Ethernet specification for 10BASE-T.
• Connector on transceiver body is standard RJ-45 type for connection to unshielded twisted
pair (UTP) Ethernet cable. .
• This unit has an attached 40" (1 meter) cable with standard 14-pin AAUI connector for
connecting to a Series 90-30 Ethernet module (IC693CMM321) or CPU with Ethernet
interface (IC693CPU364/CPU374).
• SQE option is enabled.
• Power and Link Integrity LED indicator lights.
LI
40 inches
1 meter
14-Pin AAUI
Connector
8-Pin RJ-45
Connector
3.5" (89 mm)
1"
(25mm)
1.8"
(46mm)
8 9 10 1112 13 14
765432 1
Figure J-1. IC649AEA102 Ethernet 10BASE-T Transceiver
Power Requirement
This unit draws 60 mA @ 5Vdc from the Ethernet interface via the AAUI connector.
LED Indicator Lights
These are located on the end of the unit next to the RJ-45 connector. The one labeled LI stays on
as long as Link Integrity is maintained. The one marked with a “jagged arrow” symbol indicates
the presence of 5Vdc power to the unit.
J
Appendix
To Next Page
Loading...
