10-60 Series 90-30 PLC Installation and Hardware Manual – August 2002 GFK-0356Q
10
Table 10-11. Wire List for 24-Pin Connectors
Pin
Number
Pair # Wire Color Code Pin Number Pair # Wire Color Code
A1 1 BROWN B1 7 VIOLET
A2 1 BROWN/BLACK B2 7 VIOLET/BLACK
A3 2RED B3 8WHITE
A4 2 RED/BLACK B4 8 WHITE/BLACK
A5 3 ORANGE B5 9 GRAY
A6 3 ORANGE/BLACK B6 9 GRAY/BLACK
A7 4 YELLOW B7 10 PINK
A8 4 YELLOW/BLACK B8 10 PINK/BLACK
A9 5 DARK GREEN B9 11 LIGHT BLUE
A10 5 DARK GREEN/BLACK B10 11 LIGHT BLUE/BLACK
A11 6 DARK BLUE B11 12 LIGHT GREEN
A12 6 DARK BLUE/BLACK B12 12 LIGHT GREEN/BLACK
CONNECTOR
3 2 1
12
12
3 2 1
B ROW
A ROW
NOTE
Each wire pair has a solid color wire and that same color
wire with a black tracer. For example, Pair 1 has a solid
brown wire paired with a brown wire with a black tracer.
Connector Depth for Custom Built Cables
Because custom built cables use a straight connector, they require more space in front of the PLC
than is required for a factory built cable, which has a right-angle connector. The following figure
shows the space required in front of the PLC when this cable is connected to a module. The depth
of the cabinet that the PLC is mounted in should allow for the depth added by this connector.
To Next Page
Loading...
