GFK-0356Q Appendix E IC690ACC903 Port Isolator E-7
E
Specifications
Mechanical
RS-485 15-pin D shell male for direct mounting to serial port on the programmable
controller
15-pin D shell female for communication cable
Installation Hardware Two M3 thread connector thumbscrews. Recommended torque: 8 in./lbs. (0.9
Newton-meter). These are supplied with Isolator.
Two user supplied #6/32 (4mm) thread panel mounting screws. Recommended
torque: 12 in./lbs. (1.4 Newton-meter)
Electrical
Voltage Supply
Typical Current
+5VDC (supplied by port)
25 mA
100 mA available for external equipment
Ground Isolation
Conformance
500 Volts
EIA-422/485 Balanced Line
Operating
Temperature
0
°
- 60
°
C (32
°
- 140
°
F)
Baud Rate
Those supported by PLC
Note: This appendix is based on Data Sheet GFK-1663.
To Next Page
Loading...
