10-38 Series 90-30 PLC Installation and Hardware Manual – August 2002 GFK-0356Q
10
IC693CBL306/307 Extension Cables (50-Pin) for 32 Point Modules
Function of cable
This cable is used with 32 point High Density modules that have a 50-pin male Honda connector
mounted on the front of the module. The extension cables have a 50-pin male connector on one
end and a 50-pin female connector on the other end. This cable provides a connection from the
module to a connector mounted on a DIN-rail-mounted terminal block assembly. This cable is
wired pin-to-pin (That is, pin 1 to pin 1, pin 2 to pin 2, etc.). The modules that use these cables
are: IC693MDL652, IC693MDL653, IC693MDL750, and IC693MDL751.
The connector on the module is oriented with the notch towards the top of the module with pin 1 at
the top of the right row of pins as you are looking at it, as shown below:
1
33
19
18
50
32
Cable Specifications
Cable Length
IC693CBL306
IC693CBL307
3 feet (1 meter),
6 feet (2 meters)
Connectors
50-pin female Honda on end that connects to male connector on module.
50-pin male connector on end that connects to Connector Interface Assembly.
We recommend the use of a terminal block for connecting field wiring to the 50-pin high-density
I/O modules. The use of a connector interface provides a convenient method of terminating field
wiring to the modules.
Weidmuller Electrical and Electronic Connection Systems makes a suitable terminal block
assembly RS-MR 50 B, catalog number 912263 (female Honda connector). An example of using
an IC693CBL306 or 307 cable to connect a 32 point I/O module to one of these terminal blocks is
shown in the following figure.
To Next Page
Loading...
