Chapter 8 - Replacement Procedures 8-53
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
8-4-9-5 BEP PCB Installation Procedure
1.) Reconnect the BEP PCB using four screws in the PCB corners using Phillips screwdriver
2.) Reconnect the following cables at the back of the BE:
• Two USB connectors
• Network cable
• Display port
3.) Reconnect the following cable connectors:
• SATA DATA BE TO SSD A (red cable)
Figure 8-41 Reconnect BEP PCB
Figure 8-42 Reconnect BE Cables from BE Back
To Next Page
Loading...
