Maintenance – Checking – Cleaning GEDA
®
SUSPENDED WORKING PLATFORM AB 450 / 650
Assembly and Operating Manual
70 / 96 BL061 GB Edition 04/2016
8.1.1 Documenting the results
The operating company must document the results of the checks. The
documentation must be kept for a reasonable period of time – however
at least for the entire lifetime of the machine.
x The results of the recurring check can be recorded in writing in the
appendix of this manual.
x Verification confirming the last check was executed must be attached
to the machine.
8.1.2 Checks before initial operation
Checks at the factory
The following tests have already been carried out at the factory:
- Dynamic test with 1.25 times the safe working load.
- Electrical tests according to EN 60204.
- Examination of operation.
8.1.3 Checks after assembly/daily before starting operation
To guarantee safety when handling the machine, the person appointed
by the operating company is obliged to carry out a daily inspection of
certain machine areas / parts.
Defects detected must be immediately reported to the supervisor and
rectified. Defects may only be rectified by trained personnel responsible
for repair and maintenance.
Always carry out visual inspections before function checks. Operation is
prohibited until the defects are rectified.
The following points must be checked daily
- Safety inspection before start of work
o refer to Chapter 6.2.1.
- Keep the work area around the machine clear and clean.
For checks after each set-up o
see Chapter 5.8
8.1.4 Recurring checks
Recurring checks must be carried out in accordance with national
regulations.
)
GEDA recommends that you carry out a recurring check on an
annual basis. In the event of increased demand (e.g. multiple shift
operation), carry out checks at shorter intervals.
To Next Page
Loading...
