Gefen EXT-UHD600A-44 User Manual

page | 138
Advanced Operation
Commands
#set_gateway
Sets the gateway address for the matrix. The gateway address will be changed only if the
matrix is in static IP mode. If the matrix is using DHCP mode, then the gateway address is
automatically assigned by the DHCP server. The matrix must be rebooted after executing
this command.
Syntax
#set_gateway addr
Parameters
addr
Type: IP ADDRESS
The desired gateway address of the matrix. This address must be entered
in dot-decimal notation.
Example
#set_gateway 10.5.64.1
GATEWAY 10.5.64.1
REBOOT TO APPLY SETTINGS
Related Commands
#get_gateway
#get_web_port
#get_ip_address
#get_ip_mode
#get_ipcong
#get_mac_addr
#get_netmask
#set_web_port
#set_ip_address
#set_ip_mode
#set_netmask
Advanced Operation

Gefen EXT-UHD600A-44 Specifications

General

Brand	Gefen
Model	EXT-UHD600A-44
Category	Amplifier
Language	English