Reference Manual Preliminary
Prox–DU & Prox–SU
www.gemalto.com Release for first samples Do not use for final design
DOC118569A Public Use Page 12/134
Introduction
This reference manual provides information on the use of the Prox–DU and the Prox–SU
dual interface (contactless and contact) USB smart card reader/writer.
This document is applicable to following reference:
Model Reference Comments
Prox–DU HWP118184
Dual interface USB smart card reader
Contact & contactless
Prox–SU HWP118185
Contactless interface USB smart card reader
With optional SIM/SAM slot
Prox–DU
with stand
HWP118830 A stand is added to the Prox–DU for vertical use
Prox–SU
with stand
HWP118831 A stand is added to the Prox–SU for vertical use
Table 1 – Dual interface USB smart card reader/writer models
For information on installation, please refer to the “Installation Guide” document.
Who Should Read This Book
This reference manual is designed for developers of PC/SC smart card application or driver.
For driver design, familiarity with the USB protocol is recommended.
Conventions
Bit Numbering
A byte consists of 8 bits, b7 to b0, where b7 is the most significant bit and b0 is the least
significant bit.
One byte b7 b6 b5 b4 b3 b2 b1 b0
Byte Numbering
A string of n bytes consists of n number of concatenated bytes: Bn…B3…B0.
Bn is the most significant byte and B0 is the least significant byte:
A string of
n bytes
Bn Bn-1 - - - B2 B1 B0
Contact Our Hotline
If you do not find the information you need in this document, or if you find errors, contact the
Gemalto hotline at http://support.gemalto.com/
.
Please note the document reference number, your job function, and the name of your
company. (You will find the document reference number at the bottom of the document.)
To Next Page
Loading...
