Gemalto Prox-SU - Update Binary Command

Reference Manual Preliminary
Prox–DU & Prox–SU
www.gemalto.com Release for first samples Do not use for final design
DOC118569A Public Use Page 53/134
CLA INS P1 P2 Lc
FFh B0h ABLM ABLL 10h
1 byte 1 byte 1 byte 1 byte 1 byte
The response is formatted as follows:
Data SW1 SW2
16 bytes 1 byte 1 byte
Where:
ABLM Address Block MSB 00h
ABLL Address Block LSB
MIFARE
®
1K
MIFARE
®
4K
MIFARE
®
Ultralight
00h – 3Fh
00h – FFh
00h – 0Fh (*)
Data
16-byte of data. (The first byte of
the block is byte 0)
Present only when there is no
error in the status report.
SW1-SW2 Command execution status
Command executed successfully 90 00h
Others Refer to the error codes table below
Note:
For MIFARE
®
1K and MIFARE
®
4K, it is mandatory to perform the General Authenticate
command before each read memory block operation. Otherwise, an authentication error will
occur.
For MIFARE
®
Ultralight the General Authenticate operation is not required. Refer to the
appendix for the MIFARE
®
Ultralight read operation.
Update Binary command
The Update Binary command is used to write data into a MIFARE
®
memory block.
Data consist of a memory block (16 bytes).
This command is formatted as follows:
CLA INS P1 P2 Lc DATA
FFh D6h ABLM ABLL 10h Data