Reference Manual Preliminary
Prox–DU & Prox–SU
www.gemalto.com Release for first samples Do not use for final design
DOC118569A Public Use Page 54/134
1 byte 1 byte 1 byte 1 byte 1 byte 16 bytes
The response is formatted as follows:
SW1 SW2
1 byte 1 byte
Where:
ABLM Address Block MSB 00h
ABLL Address Block LSB
MIFARE
®
1K
MIFARE
®
4K
MIFARE
®
Ultralight
00h – 3Fh
00h – FFh
00h – 0Fh (*)
Data
16-byte of data (The first byte of
the block is byte 0)
Present only when there is no
error in the status report
SW1-SW2 Command execution status
Command executed successfully 90 00h
Others Refer to the error codes table below
Note:
For MIFARE
®
1K and MIFARE
®
4K, it is mandatory to perform the General Authenticate
command before each write memory block operation. Otherwise, an authentication error will
occur.
For MIFARE
®
Ultralight the General Authenticate operation is not required. Refer to the
appendix for the MIFARE
®
Ultralight write operation.
Error code list summary
The error codes returned by the commands listed above are defined in the following table:
SW1 SW2 Meaning
Get Data error codes
62h 82h End of data reach before Le bytes (Le is greater than data length)
67h 00h Wrong length
6Ah 81h Function not supported
6Bh 00h Wrong parameter P1-P2
6Ch XXh
Wrong length (wrong number Le; XX is the exact number) if Le is
less than the available data length
6Dh 00h Instruction code not supported
To Next Page
Loading...
Need help?
General
