Reference Manual Preliminary
Prox–DU & Prox–SU
www.gemalto.com Release for first samples Do not use for final design
DOC118569A Public Use Page 72/134
Card movement notification enable
This command is use to disable or enable the smart card movement notification to the host
on the Interrupt Endpoint of the CCID interface.
At startup the card movement notification is enabled.
Note: This command is useful only with LINUX operating system.
Do not use this command with Microsoft operating system.
The command format is the following:
Offset Field Size Value Description
0 bCommandFamily 1 52h Reader command
1 bCommandType 1 F8h Management
2 bCommand 1 06h 06h
3, 4 wLength 2 0001h Size of the Data field
5 bNotification 1 0x00
0x01
0x00 = notification disabled
0x01 = notification enabled
The response format is the following:
Offset Field Size Value Description
0,1 abStatus 2 XX XX Command Status execution
2, 3 wLength 2 0000h Size of the Data field
GemCore POS Pro chip escape command
The escape commands available for the GemCore POS Pro chip controlling the contact
interface are the following:
• Firmware version request
• Slot level management (TPDU or ATPDU mode)
Refer to the documentation “GemCore POS Pro Reference manual” DOC113572 A for more
information.
PC_to_RDR_Abort command
This command is used with the control pipe Abort request to tell the CCID to stop any
current transfer at the specified slot and return to a state where the slot is ready to accept a
new command pipe Bulk-Out message.
Offset Field Size Value Description
0 bMessageType 1 72h PC_to_RDR_Escape
1 bwLength 4 00000000h
5 bSlot 1 00h Slot 0
6 bSeq 1 00-FFh Sequence number for the command
7 abRFU 3 000000h Reserved for Future Used
The response to this message is the RDR_to_PC_SlotStatus response message.
Response pipe bulk-in for the contact card interface
The following CCID messages are implemented for the contact interface:
• RDR_to_PC_DataBlock
• RDR_to_PC_SlotStatus
To Next Page
Loading...
Need help?
General
