Getinge 86 SERIES Technical Manual

Page 119 of 174
<Doc_TEC><Doc_502606900><Rel_B><Lang_GB>
Loading programs to flash memory
Theashmemorycanbeloadedwithnewwashprogramsornewsystemprograms.
LoadingnewwashprogramsrequirestheCS-1000program,whichcanbepurchased
from Getinge. Instructions are supplied with CS-1000. System programs are loaded with
Flashloader.
Note:
Always make a backup copy before starting work on updating system programs.
1. Connect a PC to the machine; see under Connecting a PC.
2. CheckthatthemachineisinSTANDBYmode.
3. Make a backup copy by starting CS 1000 and choosing:
Tools/PACS RAM/Upload To File...









V1544
V1577
4. Savethe*.prmleinyourchosenlocation.
The program will report an error during conversion. Disregard this. To check that
conversionwassuccessful,checkthesizeofthe*.prmle.Thesizeoftheleshould
be 84416 bytes.
5. Switch off the power to the machine with the main switch.
6. Change the jumper (X29) on the board for the PACS 300 control system from
Normal to Test.
X29

Getinge 86 SERIES Specifications

General

Brand	Getinge
Model	86 SERIES
Category	Cleaning Equipment
Language	English