GRAPHTEC FC2250 Series - Page 66

4-15
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
registrationmarkscanbedetected)buttheoatingupofthemediumfromthesurfaceoftheplotterordirtonthe
medium may cause erroneous detection.
Make settings for registration mark pattern 3, Mirror 1 and Mirror 2 in the same way.
Adjusting the Sensitivity of the Registration Mark Sensor
If you have changed the medium to a different type, we recommend that you perform this procedure.
(1) Press the [PAUSE] key to select ntil the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
MARK TOOL U/D
BUFFER CLR. VIEW
(4) Press the [F1] key (MARK) to display the registration mark functions selection menu.
FORCE OFFSET
SPEED QUALITY
MODE DIST ADJ
TYPE OTHER SETUPS
(5) Press the [F4] key (OTHER SETUPS) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
SIZE ADJ. SENS
ORG OFT SENS OPT
(6) Press the [F4] key (SENS OPT) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
LEVEL
SENS SPD SENS STEP
(7) Press the [F1] key (LEVEL) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
SENSOR ADJ TYPE 3
1,2 TYPE MIRROR
(8) Press the [F1] key (SENSOR ADJ) to display the menu for adjusting the sensitivity of the sensor.
FORCE OFFSET
SPEED QUALITY
SENSOR ADJUST
DEFAULT ADJUST
(9) To adjust the sensitivity value, press the [F4] key (ADJUST) to display the following prompt. To select the default
value, press the [F2] key (DEFAULT).
FORCE OFFSET
SPEED QUALITY
MOVE TO ADJ. POINT
PRESS ENTER KEY!