GRAPHTEC FC2250 Series - Page 67

4-16
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
(10) Use the [ ] [ ] [ ] [ ] keys to move the pen carriage (the tip of the tool selected by the current setting) to
a blank area of the medium (an area where there is no drawing) and then press the
[ENTER] key. The prompt
shown at the left is displayed during the adjustment process, and the prompt shown at the right is displayed when
adjustment has been completed.
FORCE OFFSET
SPEED QUALITY
FORCE OFFSET
SPEED QUALITY
SENSOR ADJUST
PLEASE WAIT
SENSOR ADJUST
COMPLETED