5-9
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.8 Setting the Overlay Function
The Overlay function enables repeated cutting to be performed on a medium that cannot be cut with one
cuttingoperation.Intherstcuttingoperation,acuttingforcethatislighterthanthespeciedFORCEvalue
is used to leave cutting trace marks on the medium. For the second and subsequent cutting operations, the
speciedFORCEvalueisused.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
I/F FUNCTION
TOOL COND AREA OPT
(3) Press the [F2] key (TOOL COND) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
THICK CUT LINE
TOOL No. ADJ.T POS
(4) Press the [F1] key (THICK) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
THICK No.
OVERLAY
(5) Press the [F2] key (OVERLAY) to display the overlay settings screen.
FORCE OFFSET
SPEED QUALITY
Blinking cursor
COND No. 12345678
OVERLAY -9-7-6-4
The upper row of the display represents the cutting condition COND Nos. The lower row of the display indicates the
numberofoverlayoperationsthathasbeenspeciedforeachCONDNo.
Use the [ ] or [ ] key to move the blinking cursor to the COND. No. for which you want to specify the Overlay
function, and the
[ ] or [ ] key to select the number of overlay operations.
Setting range:
-
(Off), 2 to 9 (times)
Press the
[ENTER] keytoconrmyourselection.
(6) Press the
[PAUSE] key to cancel PAUSE mode.
•
These settings are retained in the plotter's internal memory even while the plotter is turned off.
•
If there are no data delimiter commands (such as F0 or PG), the plotter waits for a timeout (approx. 10 s) and then
starts the second cutting operation. In this case, the following screen appears, and operations such as changing the
COND No., making PAUSE menu settings and setting the origin cannot be performed until 10 seconds have elapsed
after all the cutting operations have been completed.
FORCE OFFSET
SPEED QUALITY
PREPARING TO RECUT
To Next Page
Loading...
