7-17
7
Press the [2] key (TYPE No.).
TYPE No. screen is displayed.
8
Press the POSITION ( ) keys and select the TYPE No.
Supplement
CUT L and UP L is displayed when the TYPE
No. 0-7 is selected. Also, you will be able to
set the UP MODE.
Setting for all becomes enabled when USER
is selected.
Nothing will be displayed when "OFF" is
selected.
9
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\35(9,286
TYPE No. will be selected and it will return to CUT LINE PATTERN
screen.
Supplement
You can set the range between 1 and 48, and
"UP".
10
Press the POSITION ( ) key (UP MODE).
UP MODE screen is displayed.
Supplement
Value set here will be the cut force for the
uncut part of the perforated lines. Tool will be
raised when set to "UP".
Normally, input the smaller value than the
FORCE for cutting to make it half cutting.
11
Press the POSITION ( ) keys and set the UP MODE.
12
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\35(9,286
It will return to UP MODE screen.
To Next Page
Loading...
