GRAPHTEC FC9000 Series - Page 168

7-18
Supplement

If the TYPE No. 0 to 7 is selected in step
8, CUT L and UP L is only displayed, and
not possible to change. Skip this step, and
proceed.

Range possible to set for the CUT L is 0.1 mm
to 100.0 mm.

Range possible to set for the UP L is 0.1 mm
to 10.0 mm.

Press the [SLOW] key to select the setting
digits.

If the CUT LENGTH is too long or the UP
LENGTH is too short, the media may get
caught.
 ,QWKDWFDVHDGMXVW%/$'(/(1*7+&87
LENGTH and UP LENGTH.
13
If the "USER" is chosen in step 8, press the [3] key (CUT
L.) and the [4] key (UP L.) to set the cut length and tool up
length.
Follow steps 10 to 12 for this operation.
Supplement
It will return to CONDITION setting screen (3/3)
without changing the settings when you press the
[ESC] key (CANCEL).
14
 &RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7LQWKH
CUT LINE PATTERN screen.
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR&21',7,21VHWWLQJVFUHHQ
(2/3).
15
Press the [COND/TEST] key.
It will return to the default screen.