GRAPHTEC FC9000 Series - Setting Initial Blade Control Position Adjust

7-19
7.6
Setting Initial Blade Control Position Adjust
$IWHUWXUQLQJRQWKHSRZHURUFKDQJLQJSHQFRQGLWLRQVHWWLQJVWRXFKWKHEODGHWRWKHPHGLDDQGDGMXVWWKHEODGH
direction. The Initial Blade Control Position will need to be set in order to make sure the area is not damaged and
that the blade properly makes contact with the media.
Selecting "2mm BELOW" will change the Initial Blade Control Position to 2 mm below the cutting start point (2 mm
from the edge of the point from which the media will be shifted.)
6HOHFWLQJ<2876,'(ZLOOLQLWLDOL]H,QLWLDO%ODGH'LUHFWLRQ6HWWLQJRXWVLGHWKHFXWWLQJDUHD
6HOHFWLQJ63(&,),('<326,7,21ZLOOLQLWLDOL]H,QLWLDO%ODGH'LUHFWLRQ6HWWLQJDWWKH<GLUHFWLRQÀ[HGSRVLWLRQ
that has been set.
* When media narrower than the set Y position is set, it will be the Y maximum value.
Feed direction of media Feed direction of media
2mm
Push roller
Initial Blade Control Position
Setting Point (Set as
"OUTSIDE")
Cut Start Point (Cutting Origin
Point)
Initial Blade Control Position
Setting Point (Set as "2mm
BELOW")
Cutting area
CAUTION
Selecting [Y OUTSIDE] and then changing the expand setting to a positive digit (8 mm ABOVE) can damage the cutting mat.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/4) is displayed.